- Chronosync not running when locked how to#
- Chronosync not running when locked install#
- Chronosync not running when locked mac#
not concerned about losing any data on the computer& don’t have any backup/recovery disks
Chronosync not running when locked install#
so I’m just wondering exactly what to buy when looking to purchase a new set of install disks, please be as specific with this as possible as I’m getting overwhelmed with all the different versions & names, thank you I appreciate your time. I don’t have the original install disks but I know it came with osx 10.5.2 and is a macbook 4,1.
Chronosync not running when locked how to#
Then restarted into single user to try deck process but the last line stops at system uptime in nanoseconds:23735473361 and won’t let me enter anything, i also took a picture of the screen but I’m not one to post comments or questions much so I don’t even know how to upload or show that to anyone in this comment. Booted in verbose mode& was able to take picture of the log on my phone.
Chronosync not running when locked mac#
Have an old macbook that I believe is having a kernel panic issue(won’t boot stuck on restart your computer message) won’t boot inyo recovery mode, tried safe mode&after selecting Mac HD was stuck on white screen then shut off. I’m tempted to stop it but I’m afraid to cause a greater damage on an already bad HD. I’ve tried the single mode twice, the first time due to low bat it shut down, my bad, so I’ve agian with the power on and it is over 6 hours… Hfs_mountfs: hfs_early_journal_init indicate external jnl Hfs_mountfs: hfs_mountfs returned 22, rvp (0xffffff8038ba5f00) name (unknow device) However, after 6hours I still don’t get the blinking cursor enabling me to type the command… I know I have to be patiente but I started to think over 6 hours is quite long.Īs I’m no expert on this I started to think it is repeating the command over and over and they are basically:
There is clear a serious issue with HD so my last ditch effort was the fsck -fyd command on single mode.
I’ve been experiencing some trouble with my MBP early 2011, running on Mavericks, but last night it completely gave up and is beyond repair by Disk utility, as I tried many advices from the web. Keep in mind that if the ‘fsck’ tool continuously fails or reports errors and Disk Utility is a no go as well, the hard drive itself very well may be failing and on its last legs, so be sure to initiate a back up all of your critical data using Time Machine or your backup method of choice, and aim to get the drive replaced sooner than later. Once OS X is booted again, it can be a good idea to confirm all is well by going back to Disk Utility and running the “Verify” tool to check on the drives health. Type “reboot” to leave Single User Mode and boot the Mac back into OS X as usual.Once fsck completes, if you see a “File system was modified” message, then you should run “fsck -fy” again until you see a message stating “The volume (name) appears to be OK” – this is standard procedure of using fsck.When the Single User boot sequence has finished, you’ll find a small command prompt at the bottom of the screen prefixed by a hash sign (#), when you see that type the following command exactly:.Boot the Mac into Single User Mode by holding down Command+S during system boot after you hear the boot chime, you know you will have successfully entered Single User Mode because you will see a bunch of white text on a black background scroll by.How to use Single User Mode and fsck to repair a disk
0 kommentar(er)
